ShawnCoutts
Programmer
Im not entirely sure if this is the right spot for this question or not, but I guess Im going to ask it anyhow.
In the packaging wizard, when it gets to the point where you can determine where additional files are installed, it gives me a number of macros that I can use to determine what directory. My problem is that I do not want to install these files into any dir that the macros will allow, and cannot figure out how to do this without using the macros. I attempted to modify the SETUP.LST file by hard coding the correct install dir for the files, but am continuously getting an "invalid command-line parameter" error. How can I get around this?
In the packaging wizard, when it gets to the point where you can determine where additional files are installed, it gives me a number of macros that I can use to determine what directory. My problem is that I do not want to install these files into any dir that the macros will allow, and cannot figure out how to do this without using the macros. I attempted to modify the SETUP.LST file by hard coding the correct install dir for the files, but am continuously getting an "invalid command-line parameter" error. How can I get around this?