Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
using primary slave channel on a raid 0 setup
- Thread starter suzook
- Start date
suzook,
Your post is a bit confusing.
If this is correct, then you can connect another drive to any available IDE channel with no percievable hit on performance or otherwise.
Hope this helps
rvnguy
"I know everything..I just can't remember it all
Your post is a bit confusing.
As you are employing "RAID 0" you have at least 2 drives connected. I assume that you are using "IDE" drives and not SATA.
If this is correct, then you can connect another drive to any available IDE channel with no percievable hit on performance or otherwise.
Hope this helps
rvnguy
"I know everything..I just can't remember it all
- Status
Similar threads
- Locked
- Question