Can anyone offer an example of the correct syntax for luxadm to display if it has fast_write enabled on any of the disks in an enclosure and then how to enable this. I am trying to figure out the commmnands but am having a hard time. Command syntax type (for enabling fast_writes) luxadm -v fast_write -e pathname and (to display disk status) luxadm -v display enclosure,dev pathname
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Using luxadm command to check/enable fast writes on drives in enclosur
- Thread starter froggger
- Start date
Similar threads
- Locked
- Question
- Locked
- Question