ArevProgrammer
Programmer
Hello,
I have a Form which I am using the DataEnvironment that has (1) table in it. On the Form, I have a Search button that runs a rountine in a procs.prg file. Buffering for this Form and DataEnvironment is set to Pessimistic. The DataSession is set to Default. When my rountine runs and completes, Focus is set back to the Form, and Buffering is
evidently turned off because when I try to close the Form, or Append a new record or anything that requires buffering, I get a message stating that table buffering is required.
I am not sure where or when and at what point I need to enable buffering, and even in doing so, if it will cure this problem without restarting the Form to re-establish the DataEnvironment.
Regards
Scott K
Rome was not built in a day. Be patient!
I have a Form which I am using the DataEnvironment that has (1) table in it. On the Form, I have a Search button that runs a rountine in a procs.prg file. Buffering for this Form and DataEnvironment is set to Pessimistic. The DataSession is set to Default. When my rountine runs and completes, Focus is set back to the Form, and Buffering is
evidently turned off because when I try to close the Form, or Append a new record or anything that requires buffering, I get a message stating that table buffering is required.
I am not sure where or when and at what point I need to enable buffering, and even in doing so, if it will cure this problem without restarting the Form to re-establish the DataEnvironment.
Regards
Scott K
Rome was not built in a day. Be patient!