Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Using DNIS

Status
Not open for further replies.

Rich875421

IS-IT--Management
Feb 22, 2006
28
GB
I would like to use DNIS as opposed to CDN to route the calls and for reporting.

Is there a requirement to do something on the Meridian to recognise DNIS in the same way you do for CDN's

Many Thanks

Richard
 
You need to IDC the DNIS numbers to an acquired CDN. You can then route on DNIS in the master script.

You will also need to enter the DNIS numbers in Symposium in order to report on them.
 
You'll also need to set up your incoming trunks to pass DNIS (and decide how many digits of DNIS you will need to pass for it to be unique; the larger your DDI range, the more digits you will need).

We're going to have to do this when we got to a centralised IP based CC6 (currently we run TDM over eight sites), as CS1000E is limited to a thousand CDNs!!

DD
 
Sorry can you explain in more detail.

IDC?

I understand how to program the switch for CDN recognition but not DNIS (if required).
 
IDC is Incoming Digit Conversion. Basically it translates an incoming DDI number to your CDN.

If, like us, you're using a 1:1 relationship between DDI and CDN i.e. 01XXXX50000 becomes CDN 50000, then you don't need it, however, when using DNIS, you translate several incoming DDI to one CDN

01XXXX50001 is translated to 50000 but also
01XXXX50002 is translated to 50000 and
01XXXX50003 is translated to 50000 etc. etc

Each of the above numbers would route to the same CDN, but have different DNIS.

We have 2 x 10,000 number ranges (50000 and 60000), so we would need to have five digits of DNIS to ensure no duplicate DNIS (if we had only 4 digits, then 01XXXX50001 and 01XXXX60001 would both have the same DNIS)

The IDC table is pegged against the incoming route(s).

Use ld 21 to print the route and verify that IDC is YES and what the table number is (DCNO). Then go to ld 49 to print the relevant table DCNO. This will give you the incoming digits.

Printing the route in ld 21 will also tell you if DNIS is enabled (DNIS = YES) and how many digits are used (NDGT = 5 for example)

If you're setting it up, you'll need to build the IDC table first and then associate it to the route and then set up the DNIS digits.

DD
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top