Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Using a 1760 or a 2811 as a UK E1 PRI (ISDN30) Simulator...

Status
Not open for further replies.

tdmneil

Programmer
Jan 11, 2011
111
GB
Hi All,

I've been googling everywhere to try and find a way of setting a cisco voice router to act as a PRI simulator, but not had much luck. I've got a small CCME lab set up with a 2811 and a 1760 which all works ok- I have a 1mft-E1 Vwic that I want to use to connect to a Mitel 3300. I realise that I'll I have to make a cross over cable up which is fine, I'm not to fussed about CLI etc - I just want to be able to set up calls between the two devices by dialling from the Cisco and sending six digits to the Mitel. It's only going to be used to test configs before go live days- mainly just to make sure calls will be routed corrctly on the mitel. Does anyone have a config example or any ideas on how to configure the Cisco end at all? I've got a CCNA and basic experience of CCME so I should be ok to set it all up!
Any suggestions would be gratefully recieved!!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top