!!Urgent!! CR and Terminal Server !!Urgent!!

[Linebacker]

We developed a programm written in LJ4, a proprietary language, and use CR for reporting. It all works fine except one thing. I can not seem to run any calls for CR when logged on via Terminal Server.

Does ANYBODY have ANY experience with CR and TS and knows what might help me.

 

[pns]

I think I've seen this before, not with Terminal Services, but with Citrix. The application using Crystal didn´t work when Terminal Services was in Application Mode (a must for Citrix). As much as I can remember, we solve the problem by installing Crystal Reports on the machine with the application!
Hope this helps.

 

[ppark001]

Where I work we use terminal server for several remote locations with MAS200 (Accounting software) that uses Crystal for its reports. I know that when we install the client side of MAS200 on the remote location, MAS200 installs several Crystal files on the workstation.

We also, have to set up the ODBC driver for Crystal and use the IP address in the setup.

But, PNS is correct; installing Crystal at the remote workstation should solve the problem.