Need to upgrade the IOS on various 2950 switches located around the state. There is not enough flash to hold the current image and the upgrade image. Need some suggestions. How would you suggest I blow away the existing flash then upgrade to the new image using CiscoWorks entirely. I have a test network here locally but the devices are all over the state. So I need to make sure I am successful to avoid going on site to each device. CW2K states the 2950 image is not supported so I cannot download that as well even after applying IDU.v4-0. Just chicken that something will happen and the image will not be available to restore. Any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Upgrading IOS on Cat2950 Switch
- Thread starter odot
- Start date
Similar threads
- Locked
- Question
- Locked
- Question