Upgrading BCM 1000 from 3.6 to 4.0

[texan01]

While reading the documentation on doing this upgrade it says that the hard disk must be partitioned as shown in a table they have listed. Example, Drive C: must be exactly 2623863808 bytes in size. My drive C: shows 2570396000 bytes. It has a note that says for bcm1000 systems the size of the drives can be greater than or equal to the values provided. My question is this something that I need to change or is it close enough or will it prevent the bcm from upgrading? Do I need to repartition the drives?? Thanks for any help.

 

[MagnaRGP]

If you are unsure of the drive sizes, obtain the BiT and re-image the drive at 3.6. Patch to the level you were at and restore your backup. Then proceed with your upgrade.

 

[56BelAir]

RUN THE UPGRADE WIZARD, off Nortel web site>

 

[texan01]

I have the upgrade CD's, Can Ijust run the wizard from them?

 

[56BelAir]

The wizard is a precheck tool it will tell you if your system is ready for upgrade and what memory is full if it does not pass.