Upgrade

[cellspam]

Hi all
I did an upgrade to a summit200x48 to the version 7.6 ssh.

I need to go back to the original image version the 7.1

Can some one help.

Thanks

 

[rn4it]

If you do a show switch, you'll see a secondary image. If this is the same version as you need to go back to just do the following.
use image secondary <return> It will need a reboot so do it at a time when it will impact your environment the least.
good luck

 

[cellspam]

Both image are 7.6 i need to get both of them to 7.1



Thanks

 

[rn4it]

If you have the readme files it outlines the steps, if you don't have thme I can post them tomorrow.

 

[cellspam]

Both image are 7.6 i need to get both of them to 7.1



Thanks

 

[cellspam]

thanks rn4it

 

[rn4it]

Here you go cellspam, as per Extremeware 7.6 release notes.

Downgrading “i” Series Switches
Assuming that the previous configuration is in the secondary configuration space and the previous
image is in the secondary image space:
1 If you saved a previous configuration during the upgrade process, configure the switch to use that
configuration with the use configuration secondary command.
If you did not save an earlier configuration, re-configure the switch or download a configuration at
the end of this process.
2 If you did not save the earlier ExtremeWare image in the secondary image space, download the
image using the download image secondary command.
3 Use the image in the secondary image space with the use image secondary command.
4 Verify that the above procedures were completed successfully with the show switch command.
5 Downgrade to the appropriate BootROM version. The show version command displays the
BootROM version as “Unknown” when the BootROM is downgraded.
6 Reboot the switch.

 

[cellspam]

Thanks to all i did the down grade.


Regards