Upgrade to SW 2.0

[zagi]

Did anybody upgrade system to new release of SW 2.0 (6 or 11), and what is impression? Did somebody experience some difficulties?

I upgrade it from 1.4 (25) to 2.0 (6), after this system time to time just freeze (no calling or accessing to internet, and Manager can not locate IP Office which is reachable with ping). After power of, and power on main unit, it works again (for some time). Identical things was happening after upgrading to latest 2.0 (11). But, then another problem appeared, calling from this side another using IP trunk is not working any more, but from another side to this is fine.

Cheers!

 

[MrIPO]

Our office switch has been running 2.0(6) and then Build (11) and now (14) with no problems as far as locking up. We have found many bugs with (11), and these should be resolved in 15. Well hopfully beacuse it's going GA soon.

Voip trunking seems to be OK, and Small Community Networking. 2 way speech no issues. Are you using SCN or stright VPN, sorry VoIP Lines and Shortcodes

Mainly waiting for the latest VM release.

 

[crashtest1000]

Runnig V2 at 4 sites Release 6 and 11 haven't had any reset issues thus far.

Make sure you give the feed back to NPI so the bugs can be sorted.

 

[fonedoc]

Zagi:

I want to make sure that you did the upgrade the in the proper order. Was the IP Base unit an IP403? If so it must be done in 2 steps. You must first upgrade the unit to 1.99(Build1003) and then change your Upgrade Directory to upgrade it to 2.x.

Hope this helps!

fonedoc

 

[mm111]

Where do I get R2.0 software upgrade for IP 403. I am at load R1.4 now.

 

[MrIPO]

To get V2.0 you would need to be a registered trial site through a reseller of IPO, or a orthorised distributor for AVAYA..

The current versions are for your reference

ADMIN 2.0(15)
USER 2.0(13)
PwerConf 2.0(7)
VM Pro 2.0(16)