nnconcerts
Technical User
Has anyone done an upgrade from 4.2.1 to 5.3 on an AIX box which is either an F50 or J50 model such as 7013 and 7025. Do let me know what problems you have encountered.
Thanks
NIcholas
Thanks
NIcholas
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Upgrade on a J50/F50 from 4.2.1 to 5.3
- Thread starter nnconcerts
- Start date
- Status
I have upgraded from 4.3.3 to aix 5.1 without err, but when I tried to do any upgrade from 4.2 to 4.3 I had problems.
I hope this helps. Craig
I hope this helps. Craig
AIXSPadmin
MIS
I know for sure you cannot go to 5.3 because it won't be released until next yesr (2004), but it won't cause you any problems. I have migrated a few SP nodes to 5.1 and am migrating another one this weekend and have never had any problems with the migration.
ChristopherMartin
Technical User
Hi,
AIX 5.3 is not out yet, AIX 5.2 has just been released. IBM have dropped MCA support in 5.2, so it will not install on the J50, the F50 will support AIX 5.2 as it has the chrp architecture, it will also not support rspc architecture (The older 7043's etc) I may be installing AIX 5.2 on a apare F50 next month.
Chris Martin
pSeries Consultant
UK
AIX 5.3 is not out yet, AIX 5.2 has just been released. IBM have dropped MCA support in 5.2, so it will not install on the J50, the F50 will support AIX 5.2 as it has the chrp architecture, it will also not support rspc architecture (The older 7043's etc) I may be installing AIX 5.2 on a apare F50 next month.
Chris Martin
pSeries Consultant
UK
- Thread starter
- #6
nnconcerts
Technical User
Yes, I spoke to IBM and I was told the CHRP F50 model will be supported with the migration to a 5.2.
The RS6K chipset Model j50 won't be supported but you can go to a 5.1 OS. This is a possibility. I am more concerned with the low spaces I have
1024-blocks Free Used
/ 163840 38248 77%
/usr 1114112 602364 46%
/var 32768 20496 38%
/tmp 327680 298424 9%
With these number, will I run in to any space issues as it should check for space before it installs, perhaps that would take care of it, but then what if I am left with just a few blocks?
I will suggest the migration but the management has to take the risk. I know it can be done.
The RS6K chipset Model j50 won't be supported but you can go to a 5.1 OS. This is a possibility. I am more concerned with the low spaces I have
1024-blocks Free Used
/ 163840 38248 77%
/usr 1114112 602364 46%
/var 32768 20496 38%
/tmp 327680 298424 9%
With these number, will I run in to any space issues as it should check for space before it installs, perhaps that would take care of it, but then what if I am left with just a few blocks?
I will suggest the migration but the management has to take the risk. I know it can be done.
- Status
