Upgrade of 406 to 3.2.61 -- No Intercom Beeps 1

[IPXTech]

Hey all. Just an odd issue here. I upgraded a customer from 3.2.57 to 3.2.61 last night, and today anytime they intercom they have no warning beeps on either end. They did before, and I've looked through Manager pretty much everywhere and haven't found anything out of place.

Anyone else run into this?

Thanks!

 

[IPXTech]

Just found the answer to my own question.

Got on the blower with Catalyst. I guess it's a known issue on 3.2.61. Going to have to downgrade them for now, then upgrade to 4.0 at a later date when I can make a trip out.

 

[Bas1234]

You mean the busy tone?
Try System > Telephony > tick "Local Busy Tone"


greetzz....Bas

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________

 

[ProviderReborn]

I think he is on about the confirmation blips.

ACA - IP Office Implement
ACA - IP Telephony
CCENT - Cisco ICND1
CCNA - Working towards.

 

[1043]

I wouldn't use 4.0.anything. Wait fotr the maintanence release of 4.1 read this

http://support.avaya.com/japple/css...eID=328264&temp.bucketID=162326&PAGE=Document

 

[IPXTech]

Indeed, I'm talking about the confirmation. The little "beep-beep-beep" you hear when you use Dial Direct. Going to downgrade them, and probably keep from using 4.0+ until the next maintenance release, as there's a few issues that I'm coming to learn about that might cause some bigger issues.