IPOtech111
Programmer
Currently in the process of upgrading from 11.1.0.0 build 237 to 11.1.0.1 build 95. This is a server edition select, single virtual primary server and a IP500 expansion.
According to the 11.1 upgrade documentation regarding the special 11.1 upgrade process- "11.1GA and Future Upgrades
This is a one-off process for upgrading existing pre-R11.1 system. Upgrades of systems already on R11.1 can
use the traditional ISO upgrade methods to upgrade to R11.1 SP1."
Has anyone else performed an upgrade from 11.1 GA to 11.1 SP1 using the standard process and had success?
The server seemed to take the upgrade just fine via the iso transfer and using web manager but I am having trouble with the IP500 expansion. Upgrading it from web manager I let it run for about 2 hours and it got up to 8% complete but just sat there for a very long time. Thinking that it was stuck I rebooted it and attempted to upgrade it from manager. I changed the required security settings (enabled program code and set the service access source to unrestricted) but when I went to the upgrade wizard the unit populated but was greyed out and I was not able to select it and upgrade it from manager. Can anyone verify if you are not able to upgrade a 11.1 SE expansion from manager anymore? Or if there is an additional process?
So I went back to web manager to attempt to upgrade it again from there and we are going on 5+ hours now and it is only at 14%.
Ideally I would like to just pull out the SD and recreate it on my laptop but the customer site is half way across the country and I do not have that ability.
Just looking to see if anyone else has upgraded an expansion from 11.1 GA to 11.1 SP1 and has ran into the same thing and if I should just continue to be patient or if there is something else I should be doing?
Thanks in advance.
According to the 11.1 upgrade documentation regarding the special 11.1 upgrade process- "11.1GA and Future Upgrades
This is a one-off process for upgrading existing pre-R11.1 system. Upgrades of systems already on R11.1 can
use the traditional ISO upgrade methods to upgrade to R11.1 SP1."
Has anyone else performed an upgrade from 11.1 GA to 11.1 SP1 using the standard process and had success?
The server seemed to take the upgrade just fine via the iso transfer and using web manager but I am having trouble with the IP500 expansion. Upgrading it from web manager I let it run for about 2 hours and it got up to 8% complete but just sat there for a very long time. Thinking that it was stuck I rebooted it and attempted to upgrade it from manager. I changed the required security settings (enabled program code and set the service access source to unrestricted) but when I went to the upgrade wizard the unit populated but was greyed out and I was not able to select it and upgrade it from manager. Can anyone verify if you are not able to upgrade a 11.1 SE expansion from manager anymore? Or if there is an additional process?
So I went back to web manager to attempt to upgrade it again from there and we are going on 5+ hours now and it is only at 14%.
Ideally I would like to just pull out the SD and recreate it on my laptop but the customer site is half way across the country and I do not have that ability.
Just looking to see if anyone else has upgraded an expansion from 11.1 GA to 11.1 SP1 and has ran into the same thing and if I should just continue to be patient or if there is something else I should be doing?
Thanks in advance.