upgrade check

[RYLSFAN]

I ran the 4.0 upgrade checker on my 400/3.7 and the following error was received.

FAIL: C: partition on BCM200/400 must be 2,623,863,808 bytes
FAIL: D: partition on BCM200/400 must be 9,911,427,072 bytes
FAIL: E: partition must be 2,105,638,912 bytes
FAIL: F: partition must be 2,105,638,912 bytes
FAIL: G: partition must be 2,105,638,912 bytes
FAIL: MAINTOS partition on BCM200/400 must be 1,052,835,328 bytes

I have read the read me file associated with the upgrade and it gives the following advice:

Message: FAIL: C: partition on BCM200/400 must be 2,623,863,808 bytes
Message: FAIL: Could not determine size of drive C:
Message: FAIL: C: partition on BCM1000 must be at least 2,623,863,808 bytes
Message: FAIL: D: partition on BCM200/400 must be 9,911,427,072 bytes
Message: FAIL: Could not determine size of drive D:
Message: FAIL: D: partition on BCM1000 must be at least 9,911,427,072 bytes
Message: FAIL: E: partition must be 2,105,638,912 bytes
Message: FAIL: F: partition must be 2,105,638,912 bytes
Message: FAIL: G: partition must be 2,105,638,912 bytes
Message: FAIL: MAINTOS partition on BCM200/400 must be 1,052,835,328 bytes
Message: FAIL: Could not determine size of MAINTOS drive
Message: FAIL: MAINTOS partition on BCM1000 must be at least 1,052,834,816 bytes
Explanation: Pre-Check checks the sizes of the partitions expecting the following:
If system is BCM200/400:
C: must be 2,623,863,808 bytes.
D: must be 9,911,427,072 bytes.
I: must be 1,052,835,328 bytes.
If system is BCM1000, C:, D: and I: drives may be formatted as above, but if not must respect the
following:
C: must be at least 2,623,863,808 bytes.
D: must be at least 9,911,427,072 bytes.
I: or H: must be label MAINTOS and at least 1,052,834,816 bytes.
If any of these tests fail, Pre-Check reports it.

Resolution: See standard partitioning issue resolution under FAIL: No drive C:

ANYONE KNOW WHERE I CAN FIND THE STANDARD PARTITIONING ISSUE RESOLUTION THE README FILE REFERS TO?

TIA



Thats not my fastball, thats my hurry up and get by you pitch... Satchel Paige

 

[acewarlock]

This drive cannot be upgraded, you will need to reimage the drive to correct the partion sizes.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.

 

[MagnaRGP]

Use the Nortel Bit Imaging Tool or search the forum here for how to use Ghost with the correct parameters.

I prefer the BiT, but that's just me.