mikecastdogg
IS-IT--Management
I currently run 3.1.65 and everytime I try to upgrade to 3.2 it fails while transferring during offline mode. Do I need to upgrade the loader on a 406 that is not .v1 or .v2?
Any thoughts?
Any thoughts?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Upgrade 406 to 3.2.54
- Thread starter mikecastdogg
- Start date
- Status
this is in the tech bulletin that came with 3.2
read this and be sure wich 406 you have
here the link so you can download this tech bulletin
Early IP Office 406V2 releases at PCS 4, 5 and 6 had flash size of 3MBytes allocated
for the code and 16Mbytes of RAM. These systems need to have their loader
upgraded to V2.4. This can be achieved by upgrading to IP Office version 3.0(999) –
a specific loader upgrade binary. The procedure need only ever be completed once
for a given IP Office 406V2. Once the upgrade to 3.0(999) has completed, the
system will require an additional upgrade to 3.1(999). The IP Office can then be
upgraded to 3.2. The flash is extended from 3Mbytes to 6Mbytes by uploading to
loader V2.4.
A similar issue exists for IP Office 406v1 running old versions of the loader (Branch 2
Loader 0.1) found with PCS level 03 and earlier, very few of these exist. To upgrade
to 3.2 these variants should also have their loader upgraded to IP Office version
3.0(999). The procedure need only ever by completed once for a given IP406v1.
Once the upgrade to 3.0(999) has completed the IP Office can be upgraded to 3.1.65
Women and cats can do as they please and men and dogs should relax and get used to the idea!
read this and be sure wich 406 you have
here the link so you can download this tech bulletin
Early IP Office 406V2 releases at PCS 4, 5 and 6 had flash size of 3MBytes allocated
for the code and 16Mbytes of RAM. These systems need to have their loader
upgraded to V2.4. This can be achieved by upgrading to IP Office version 3.0(999) –
a specific loader upgrade binary. The procedure need only ever be completed once
for a given IP Office 406V2. Once the upgrade to 3.0(999) has completed, the
system will require an additional upgrade to 3.1(999). The IP Office can then be
upgraded to 3.2. The flash is extended from 3Mbytes to 6Mbytes by uploading to
loader V2.4.
A similar issue exists for IP Office 406v1 running old versions of the loader (Branch 2
Loader 0.1) found with PCS level 03 and earlier, very few of these exist. To upgrade
to 3.2 these variants should also have their loader upgraded to IP Office version
3.0(999). The procedure need only ever by completed once for a given IP406v1.
Once the upgrade to 3.0(999) has completed the IP Office can be upgraded to 3.1.65
Women and cats can do as they please and men and dogs should relax and get used to the idea!
- Status
Similar threads
