UNRG display on CS1000 3

[richieja]

Nortel CS1000 (MG1000) display UNRG then error E002. Any suggestions?

 

[Firebird Scrambler]

I found this below

MGC displays
The Media Gateway Controller (MGC) faceplate four character display
provides feedback to the technician on the diagnostic status of the MGC
during power-up and on its operational state when in service.

Display output Meaning
BOOT This is the first message when the display becomes active.

POST Power On Self Test. This message is displayed while the MGC
is carrying out hardware system tests during system power up.

PASS Power on self test pass.

LOAD Application software is loading.

LLLS1 IPMG super loop and shelf number where LLL is the superloop number and S is the shelf number. For example,. 0320, or 1201.


Display output Meaning

E001 A 96 port daughterboard is installed in DB position 2; this is not supported.

E002 Unable to send a registration request to the call server.

E003 Link is down to the call server.

E004 Daughterboard is not registered with the call server.




Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.com

linkedin

 

[bignose21]

guessing this is for the same switch on your other thread, if the callserver is down that thats why the MG is E002. Callserver needs to be Green on the top light of the CPPM.