admiralzino
IS-IT--Management
we have MD110 connected to a TETRA system. when you dial a radio from an extension, if the radio is not available, switched off or does not exist, it gives the same tone - line lock out/vacant number tone. is there a way to pragram the MD110 to recognise the different condition codes.
see capture from the Telephone interconnect of the TETRA radio:
Radio OFF :
[08/15/06 16:51:08] Call Termination - Single Call Term Record ; Interconnect Call Type = Land to Mobile ; Call Duration = 0 seconds ; OL Call# = (0) ; Destination SubscriberID = 2717 ; Subscriber = 2717(0xA9D)[None]Undefined ; Call Features Used = 0040 ; Route# = 0 ; Port GroupID = Default ;
Not Connected :
[08/15/06 16:57:04] Call Termination - Single Call Term Record ; Interconnect Call Type = Land to Mobile ; Call Duration = 0 seconds ; OL Call# = (0) ; Destination SubscriberID = 2717 ; Subscriber = Undefined ; Call Features Used = 0040 ; Route# = 0 ; Port GroupID = Default ;
see capture from the Telephone interconnect of the TETRA radio:
Radio OFF :
[08/15/06 16:51:08] Call Termination - Single Call Term Record ; Interconnect Call Type = Land to Mobile ; Call Duration = 0 seconds ; OL Call# = (0) ; Destination SubscriberID = 2717 ; Subscriber = 2717(0xA9D)[None]Undefined ; Call Features Used = 0040 ; Route# = 0 ; Port GroupID = Default ;
Not Connected :
[08/15/06 16:57:04] Call Termination - Single Call Term Record ; Interconnect Call Type = Land to Mobile ; Call Duration = 0 seconds ; OL Call# = (0) ; Destination SubscriberID = 2717 ; Subscriber = Undefined ; Call Features Used = 0040 ; Route# = 0 ; Port GroupID = Default ;