colduphere
IS-IT--Management
Run on an NX CLEARPATH 4800. Currently using MCP 47.1. Users connect to Nx using Nxview, versions 5 and/or 6. On occasion Nxview users start losing their connections. The system can be busy or not busy. Start getting the following messages on the ODWs:
reset sent due to syn received for unknown port remote ip address = blah, remote prot = blah All the users lose their connections. We use to halt/load. However now we 'wait it out' usually. After about twenty minutes users are then able to sign back on using nxview. Any ideas of some things we could look at would be appreciated.
reset sent due to syn received for unknown port remote ip address = blah, remote prot = blah All the users lose their connections. We use to halt/load. However now we 'wait it out' usually. After about twenty minutes users are then able to sign back on using nxview. Any ideas of some things we could look at would be appreciated.