Unable to mov trunk lines

[Narinekevinpooran]

Hello,

i've used the MOV command in LD25 to move a XCOT/PPM universal trunk card from one loop to another.

Req > mov
Cust
SRCL 12
DRCL 20
SHCD 0 10 TO 0 6

This worked

I tried it again and it didn't

Req > mov
Cust
SRCL 00
DRCL 20
SHCD 1 2 TO 0 8

Didn't work

I would simply line to relocate a couple of trunk line, would if be easier to just print the old trunk line TN, out the TN.
Do a new trunk in LD 14 and put back the same information that was printed.

I hope i asked that right.

 

[Firebird Scrambler]

If you are moving a trunk within the same TN card, then it should work but moving a trunk to an other card slot won't work and your option is to delete the trunk and provide it as a new one again.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.myfreesites.net

linkedin