UNABLE TO ENABLE CLIENT SETS--BCM 450

[ryanschiffino]

Hello Tek-Tips!

My company uses a Nortel BCM450 for our phone system. We have 64 key codes available but have only used 52 of them. I am unable to enable the remaining keycodes. I reviewed my Telephony Resources> IP Sets> IP Terminal Details. There is currently only 3 DNs that are listed as 'offline'. I do not believe that there is an expansion card needed because this BCM is capable of 100 on its current card. Has anyone encountered this issue? Can anyone help?

Ryanschiffino

 

[curlycord]

See if this helps:

http://www.tek-tips.com/viewthread.cfm?qid=1676004

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[snowman50]

From the Configuration tab, open the Resources folder and click on
Telephony Resources.

Select the resource that you want to renumber, and click on
Configure. IP Sets is being used as an example here, but this
procedure can apply to any of the resources

Note the warning messages and click on OK.

It should show you the next number you can continue from.
You should now be able to add more DNs to the range.
Allow extra extns so as you dont have to do this again