steveredman
IS-IT--Management
Hello,
I've been trying to set up Anyconnect on my 1801 router and have gone through all the relevant steps and it should now be working, except for the fact that the gateway webpage will not load if accessed from the public side of the router.
I have an entry in the inbound ACL on my dialer zero to allow traffic to get to TCP port 443 of my routers external IP.
The IP/port in question is not mapped to any internal resources.
If I enter the IP/port into my browser (using the https:// prefix) from the private side of the router it loads the page, but the same address from the public side gives nothing.
Any advice would be muchly appreciated.
Regards,
Stephen
I've been trying to set up Anyconnect on my 1801 router and have gone through all the relevant steps and it should now be working, except for the fact that the gateway webpage will not load if accessed from the public side of the router.
I have an entry in the inbound ACL on my dialer zero to allow traffic to get to TCP port 443 of my routers external IP.
The IP/port in question is not mapped to any internal resources.
If I enter the IP/port into my browser (using the https:// prefix) from the private side of the router it loads the page, but the same address from the public side gives nothing.
Any advice would be muchly appreciated.
Regards,
Stephen