Hello,
Can someone tell me what conditions cause a Maintenance Busy condition with the UILC / MISP Cards? Please be specific as I am interested at the signal level. could this be a case where the equipment is not shut down properly? Programming prameters? error thresholds?
We have a situation where our line hangs up periodically and we have to go in and disable/enable the card/loop.
Any help would be greatly appreciated!
.stat 56 0 15
SW DSL L2 #TEI L1 D-CHANNEL RCVYCLK MODE
==== ==== ==== ==== ==== =========
00 = MBSY LINE MBSY 0 UP
01 = MBSY LINE MBSY 0 UP
02 = MBSY LINE MBSY 0 UP
03 = UNEQ
04 = UNEQ
05 = UNEQ
06 = UNEQ
07 = UNEQ
Can someone tell me what conditions cause a Maintenance Busy condition with the UILC / MISP Cards? Please be specific as I am interested at the signal level. could this be a case where the equipment is not shut down properly? Programming prameters? error thresholds?
We have a situation where our line hangs up periodically and we have to go in and disable/enable the card/loop.
Any help would be greatly appreciated!
.stat 56 0 15
SW DSL L2 #TEI L1 D-CHANNEL RCVYCLK MODE
==== ==== ==== ==== ==== =========
00 = MBSY LINE MBSY 0 UP
01 = MBSY LINE MBSY 0 UP
02 = MBSY LINE MBSY 0 UP
03 = UNEQ
04 = UNEQ
05 = UNEQ
06 = UNEQ
07 = UNEQ