I have a UDS1100 to replace a modem for a bbs to allow it to get on the internet via the Telnet protocol.
I know there are alot of bbs' software out that already support native telnet, but this is for a legacy system. very old..
I cannot get the bbs to recognize that someone is connected to the UDS1100 device and start the board. Is there a different configuration option I need to select for the UDS device?
I am currently selected D6 for the connect mode which is a Hayes compatible modem.
I know there are alot of bbs' software out that already support native telnet, but this is for a legacy system. very old..
I cannot get the bbs to recognize that someone is connected to the UDS1100 device and start the board. Is there a different configuration option I need to select for the UDS device?
I am currently selected D6 for the connect mode which is a Hayes compatible modem.