Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations biv343 on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

UDP field "Insert Digits"...

Status
Not open for further replies.
boot2sector0

boot2sector0

MIS
Apr 21, 2006
44
US
UDP field "Insert Digits"... the valid entries are 0-9 and L1-L5 - if you have an entry in the UDP table that is only "Len" or length of 2 digits, you have to have L1-L5 in the field. Docs suggest something about the prefix in the "change locations" field being the prepended digits. What doesn't make sense about this is, if I am restricted to the single entry in the prefix field for a given location - I can't then route 66 to 221 and 67 to 223 - I would be forced to choose only 1 string of aar digits. before, I could just put

66 221
67 223

then create those 221, and 223 entries in the aar table and awaya I go....

Is anyone using this L1-L5 that wouldn't mind sharing some details explanations...

Kind Regards to all.

boot2
 
Status
Not open for further replies.

Similar threads

MIKEY-MIKE7
  • Locked
  • Question
AVAYA DEFINITY "AUDIX" TN 568 PROBLEM 1
Replies
1
Views
272
phoneguy55
phoneguy55
homemade88
  • Locked
  • Question
"Unrecoverable processing error occurred" When Loging Into SMI
Replies
6
Views
410
homemade88
homemade88
Craft01
  • Locked
  • Question
Removing patch Status stuck at "deactivating" 1
Replies
3
Views
286
JefferP
JefferP
Richard_Harrow
  • Locked
  • Question
Both security modules of session managers are showing as "down" after changing the time on
Replies
6
Views
395
mattKnight
mattKnight
BJetter
  • Locked
  • Question
DID trunk group type, can you pass more than one set of digits
Replies
1
Views
1K
JefferP
JefferP

Part and Inventory Search

Sponsor

Back
Top