Twisted pair E1/T1 cable

[ladeeh]

Hi,
I have just replaced my old 2mbps UHF radio (between two LIMs) with a new airmux-200 + 2E1 radio. The interface is now from the RJ45 E1 port on the airmux to GJUL4 card on MD110.
I am confused about the Rx and Tx pinout on the GJUL4 board using twisted pair cable.

Can someboy please give me the pinout on the GJUL4 board? I was using coax cable for the old radio.

 

[lalrl]

Rx: right PIN-side, below
Tx: right PIN-side, above

 

[ladeeh]

Lalrl,
Thanks, but can u explain further or rather diagramatically because the GJLU4 connector RNV 304012 has about 10 pins. i.e 2 pins in the middle row and 4 each the other rows.