TSW: Analogue line lock out. Need to send signl to clear.

[safron]

Hi all,

Normally i would use FTSAS, FTSSI to clear this linelock. (if not linefault) usually clears it.
This was when i had a mult calculator to convert equ to hex.

Can anybody assit with this or provide a mult calculator, so am able to use...

FTSAS:LIM=2,SIGAR=1,SIG=2,STATE=2,BYTE=1-xx&2-xx;
FTSSI:SIGAR=1;

thanks

Saf.

<susip:dir=95774&95939;
STATUS INFORMATION AT 09:34:01 23MAY12
DIR TYPE TRAFFIC STATE/PTR LINE STATE/PTR DIV STATE ADD INFO
95555 ATS LINE LOCK #0234 LINE LOCK #039C

<EXDDp:dir=95774&95939;
EXTENSION DIRECTORY DATA
DIR CUST EQU CAT TYPE ICAT MCOST AUX
95555 002-1-61-01 2 EL6 0000000

 

[BlAle]

Hi, Safron!
I successfully use the table from this site:
MML Codes for absence diversion
thread806-933520

http://www.tek-tips.com/viewthread.cfm?qid=933520

 

[safron]

This is an interesting post - thanks!

 

[himdp]

Hi,
If you are sending "ONHOOK" to ELP6, you do not use EQU as a pointer rather the device pointer which is shown in the SUSIP as the Traffic Ptr.

You have some strange printouts there, your system seems to think that 95774&95939 means 95555
Can I recomend the use of the SG commands in place of FT as the parameters are less cryptic.

e.g.
SGSAI:LIM=2,LEVEL=A,UNIT=ELP6,SIGAR=1,SIGNAM=ONHOOK,STYPE=HWSW,BYTE=0-02&1-34;
SGSSI:SIGAR=1;
Would send ONHOOK to release extension 95555.

 

[safron]

Hi HIMDP,

Yeah sorry, cut and paste gone crazy there.
Definately SG rather than FT in future for this particular issue anyways.

Cheers!..
Saf