Trying to link 3 Magixs together via point to point T-1. 1

[RCTelecom]

I have 2 Magix already network together and trying to add a 3rd location. Have set the udp for 21 for site 1, 22 for site 2, 23 for site 2 to site 3 and site 3 is 24. I get a busy when I call from site 3 to 2 and vice versa. My udp table is programmed for 890 pool and FRL of 0. Can't get site 2 and 3 working.

 

[phonesrus]

You need to configure REMOTE ACCESS to UNRESTRICTED on Tie Lines and NON-Tie Lines.

Sys Prog > Lines & Trunks > Remote Access > TIE Lines > Restriction > CHANGE IT to UNRESTRICTED


Sys Prog > Lines & Trunks > Remote Access > Non-TIE > Restriction > CHANGE IT to UNRESTRICTED

You did not specify whether you were using E&M TIE lines or PRI, but PRI is classed as non-tie, not having this set correctly will prevent you from working. I had this issue last year and Merlinman was kind enough to remind me about it.

 

[BigWill]

In order to test the TIE line you can also go into the extension field, goto to "dial outcode", and allow an extension to dial that pool number directly. Bypass your UDP Tables, your TIE barrior codes, and all that junk. That will test your Magix's by them selves. If you are doing Centralized voicemail, don't forget to unrestrict your voicemail ports (in both ways) or you won't be able to transfer from one site to the other site from the AA because of an FRL of 0, and outward restriction. Good Luck