Trying to delete a system 3 1

[M1north]

Hello,

I`m trying to remove the 3rd T1 in a system 3 setup (3x T1 with 2x DCH).

I have shutdown the 3rd PRI and removed the 23 channels from the RDB.

I tried to remove the loop (DLOP=x29) and I am getting an error saying loop still has data.

There isnt a dch programmed for this loop so unsure why I cant delete.

Thx

 

[bigindian65]

so you have a Dch and Bdch and 3 T's? That T is listed under your Dch. Chg ADAN associated with that T (x that T out of the config)

Mato' Was'aka

 

[M1north]

What prompt would I do that? Here are my 2x DCH.

Loop 2/DCH 63
Loop 18/DCH 62
Loop 29/DCH ??

TYPE adan dch 63

ADAN PRIM DCH 63
BDCH 62
CTYP MSDL
GRP 0
DNUM 15
PORT 1
DES 01IPCD841173
USR PRI
DCHL 2
OTBF 127
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC D100
SIDE USR
CNEG 1
RLS ID **
RCAP ND2
MBGA NO
PRI INTERFACE ID
029 2
T200 3
T203 10
N200 3
N201 260
K 7

REQ prt
TYPE adan dch 62

ADAN BKUP DCH 62
PDCH 63
CTYP MSDL
GRP 0
DNUM 14
PORT 1
BCHL 18
RCVP NO
OTBF 127
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC D100
SIDE USR
CNEG 1
RLS ID **
RCAP ND2
MBGA NO
PRI INTERFACE ID
029 2
T200 3
T203 10
N200 3
N201 260
K 7

 

[bigindian65]

ADAN PRIM DCH 63
BDCH 62
CTYP MSDL
GRP 0
DNUM 15
PORT 1
DES 01IPCD841173
USR PRI
DCHL 2
OTBF 127
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC D100
SIDE USR
CNEG 1
RLS ID **
RCAP ND2
MBGA NO
PRI INTERFACE ID
029 2<-------- chg adan in 17 and x29 (can't remember if
T200 3 you have to do it on B as well)
T203 10
N200 3
N201 260
K 7


Mato' Was'aka

 

[M1north]

It turns out that the PRI INTERFACE ID prompt is where you have to x29.

Thx