Trying to connect a Mitel 3300cxi to a BCM via a Trunk to Analogue Ext

[mitelsx2k]

I am tring to connect a mitel 3300 via an embedded trunk to a Bcm 50 via an analogue port on the Bcm, the systems are next to each other so we are just connecting the two together with an RJ11 to RJ11 cable.
I have made the trunk a DTS on the Mitel and programmed a key on an IP phone with the trunk number and as a key system, when you try and press the button on the ip phone you just get busy and the trunk number comes up on the screen, i have set the trunk up as loop.anyone have any ideas thanks.

 

[kwbMitel]

What happens if you loop back an analog trunk on the Mitel to the same Trunk Port?

If you still get an error, then you have issues with your programming.

**********************************************
What's most important is that you realise ... There is no spoon.

 

[LoopyLou]

Should be able to connect an analog port from a PBX, in your case a BCM to a trunk on the 3300. What happens when you call the BCM extension? Does the trunk ring.

I think kwbMitel means a anlog port on the 3300 to the analgo trunk port on the 3300. Pretty minimal programming on a 3300 for trunks so have you tried leaving it as a normal trunk and access via the trunk access code before you make it a DTS?

I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.

 

[kwbMitel]

Thanks Loopylou - Yes, I meant analog port on 3300 to same analog trunk.

**********************************************
What's most important is that you realise ... There is no spoon.