Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

trunk to trunk on opt11

Status
Not open for further replies.

trclubb

Vendor
Mar 20, 2009
83
US
have a customer with a old opt11e v-1411 rls 20.22 built a ACD dn that is NCFW to outside #. works fine if we call from insde but if we try to Xfer a call from outside will not tie the 2 outsdie callers together. trunks are on a std t-1 as DID, the tgar for the trks and sta are set to 1. what else am I missing that would stop the 2 outside callers to connect
 
On the outgoing route, check that TRMB = YES. Also check in LD 56 if you have TBAR and RART configured.

Firebird Scrambler
Nortel and Avaya Meridian 1 / Succession and BCM / Norstar Programmer

Very advance high level knowledge on the Linux BCM phone system.

Website
 
we do have TRMB set for Y i will chk ld 56 thanks
 
The NCOS on the incoming trunks may not be high enough. Compare with the NCOS on the sets.
 
Here is a little cheat sheet I made up to accomplish this

LD 15 REQ: CHG
TYPE: NET_DATA
DITI = YES
EXTT = YES
FTOP = FTLY

LD 15 REQ: RDR_DATA
CFTA = NO

LD 49 FCR
CNRO 0
INIT = ALOW

LD 20 For each phone TN that needs to be able to transfer calls to a remote number:
CLS = CTD, FTTU, CFXA
Key xx CFW 4

LD 20 For all other phone TN's at that don’t need to transfer to a remote number:
CLS = CTD, FTTC, CFXD
Key xx CFW 4

LD 23 ACD = 5001
MWC = Yes
MAXP = 1
NCFW = ACOD1234567890

LD 95 Add name for ACD
CFW to Cell,- J.Smith
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top