Trunk Load Balance across (2) 6509 switches

[Guest_imported]

I would like some opinions on load balancing across 2 6509 switches using trunk ports.

Here is the scenerio...

1 switch at the access layer, 2 switches and the distribution layer. The access layer switch has a GIG trunk link to each of the 2 dist layer switches. How would I implement equal-cost load balancing in a round robin fashion from the access layer switch to each of the 2 dist layer switches.

I would like to do this on a packet by packet level. CCO has some good tips, but only for load balancing from 1 switch to 1 switch, not 1 switch to 2 switches.

Any advice and help would be greatly appreciated.

 

[jeter]

I have been working on load balancing and we tried EIGRP and ppp multilink . This
application is to be running from 2ea 2620 routers using 2 point to point T1's . I'm
not sure that this is what your looking for, however I hope it helps .