Trunk group is NFAS setup with MM710B cards. All B channels up but D channel on 1 card showing OOS in pbx. Already tried to busy/reset/release board and even tried a new board. D channel still OOS. Vendor says they see it as blocked on our end. Any suggestions where else to look?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Trunk group setup with MM710B card in G450 but vendor says D channel is blocked in CPE
- Thread starter navy1
- Start date
smokinjoe2938
Programmer
anytime i have seen a d channel down, the b channels would be out of service, do a test board and post results
AvayaTier3
Technical User
NFAS ds1 programming should have ds1 as isdn-ext
this means d-channel is external to this t1 and allows for 24 b-channels
FAS ds1 programming should have ds1 as isdn-pri
this means 23b+1d on this t1
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]
this means d-channel is external to this t1 and allows for 24 b-channels
FAS ds1 programming should have ds1 as isdn-pri
this means 23b+1d on this t1
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]
- Thread starter
- #4
Trunk group has 2 circuits; one with primary D channel and one with secondary D channel. The secondary is up and all 46 B channels are up working. The primary D channel 24 is OOS. I can busy/release and that primary goes in standby for a couple seconds then OOS again. Both circuits are set as isdn-pri signaling mode in pbx.
AvayaTier3
Technical User
post programming
display ds1 for primary
display ds1 for secondary
display signaling-group that has primary and secondary interface 0 and interface 1
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]
display ds1 for primary
display ds1 for secondary
display signaling-group that has primary and secondary interface 0 and interface 1
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]
- Status
Similar threads
- Locked
- Question
- Locked
- Question