Trunk Extreme 250 to Extreme 250

[Hudson22]

Hi,
Can someone help me out on this?
Have an extreme 250 with an Avaya PBX and IP phones. System is all programmed and ready but need to connect another Extreme 250 off of the one already installed to use in a training environment (not enough jacks in the training room). I want to use the cat5 jack in the training room to connect to the production 250 to allow me to have about 10 IP phones in one room. I am new to extreme so any help is greatly appreciated.
thanks,
Hudson22

 

[tanderson3733]

Both switches need to have the same VLAN IDs. Then add the uplink ports to all VLANs on each switch:

config vlan default add port 1
config vlan voice add port 1 tagged

Do this on each switch, substitute the port number you will use to uplink the switches.

If you aren't using VLANs then just plug 'em in.