Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Trouble creating trunk and etherchannel between cisco and H3C switches

Status
Not open for further replies.

totalnewbie316

IS-IT--Management
Mar 3, 2011
6
GB
Hi everyone,

Having a bit of a problem creating an etherchannel trunk between a cisco 3750 and a H3C s5800 switch. My config for the cisco side is pretty standard, Ive created chanel group 1 and added the "channel one group mode active" command to the interface as i beleive this will use LACP for aggregating the ports.

However im a bit stuck on the H3C side as ive never touched it. I want to use LACP on the H3c switch though. Ive used the below commands but it doesnt work:

interface Ten-GigabitEthernet1/0/1
port link-type trunk
port trunk permit vlan all
port link-aggregation group 1

interface Bridge-Aggregation 2
port link-type trunk
port trunk permit vlan all
link-aggregation mode dynamic


Ide appreciate it if anyone could give me a helping hand as im only really familiar with cisco equipment. Thanks

 
That looks OK to me. Presumably you are matching up "Group1" with the aggregation interface "1"?

How about these on the "Bridge-aggregation" interface?

stp disable
stp loop-protection
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top