i am calling an unassigned DID in one of my switches and am getting overflow tone. This DID is 8026 and all their DIDs are in an IDC table that converts to 2xxx. So 8026 converts to 2026. Am i getting overflow tone because of a parameter in my CDB that indicates what type of treatment unassigned DNs/DIDs should get? if so, where exactly is that so I can look at it? thank you.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
treatment for unused DIDs
- Thread starter coniglio
- Start date
BMiles2000
MIS
In load 21, print the Intercept treatment data block (INT). Look at the prompt CTVN (Call To Vacant Number) prompt. This will tell you what you need to know. Instead of using IDC tables for DID's that are not in use we use a single RAN route for this, that way we do not have to up-keep our IDC tables. Good Luck!
BTW: This is setup in LD 15
BTW: This is setup in LD 15
- Status
Similar threads
- Locked
- Question
- Locked
- Question