Transferring cards with existing extensions to toher module

[dnaserver]

How can i transfer a card (analog or digital card) together
with 16 existing/active extensions to other slot or modules
without reprogramming the extensions

 

[jazaya]

Hi there:
Here is an extract from Alex:
9 EXEQC Extension Equipment Position Change
9.1 FORMAT


AUX = Auxiliary number. Secondary directory number on new position.
For value, consult parameter description for analogue extension.

DIR = Directory number. Primary directory number on new position.
For value, consult parameter description for analogue extension.

EQU = Equipment position. New equipment position.
For value, consult parameter description for analogue extension.


9.2 FUNCTION
The command is used to move an ordinary, a primary or secondary extension to a new equipment position. The earlier position is filled by an underlying secondary extension (if one exists) that is pushed upwards.

If the moved extension is a primary extension the first secondary extension to the previous equipment position will become primary extension. If the moved extension is a first secondary extension the second secondary extension will become first secondary extension.

The individual diversion number and paging always accompany the extension irrespective of the manner in which the extension has been moved.

Note: An extension must not be moved between the function blocks EL6, EL7 and EL8.


--------------------------------------------------------------------------------
This works for analog extensios and assumes that a card in new position is already initiated.You can use CNHUI:BPOS;
to initiate a new board.Let me know if you have any other questions with this regard
Hope it helps

Experience it, there is no substitute.
RemoveThisJazayeri@kiasagroup.com

 

[serg75]

dnaserver, you may apply the EXEQC command in BC10 or higher, but NEVER USE IT ON EARLIER VERSIONS - may be problems with pickup groups.