Transfer 911 Calls Automatically to PRI-A

[maxse]

How can this be achieved when I am using 5 as a dial out code on route 001. Also I have target lines that start with a 9?

Basically I dont want to have to dial 5911 for emergency just 911.

 

[phoneguy610]

Create destination digits 911 set absorb length to none then set the route to dial out over whatever line pool you want

 

[maxse]

What exactly does the absorb length do?

 

[allworxguy]

number of digits in your destination code that are sent on the PRI.

dest 911 absord none = send out 911
dest 911 absorb al1 = send out nothing

Marv

http://www.telemarv.ca

 

[maxse]

I should post this on another thread but how do I set outgoing caller id per set on the pri?

 

[curlycord]

Yes you should and note system version software too, thanks.

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[maxse]

So if my destination code is 5any to reach pri-a then the absorb should be 1 to absorb the 5?

 

[curlycord]

Any or 1 when its 1 digit.

Just setup Dest code 911 to Asorb ALL and to use route 001 which is already setup.

So now 5 and 911 will both use route 001, 001 uses PRI-A (presume).






=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[curlycord]

absorb length to none"

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[maxse]

So my 2 Dest Codes Would Be...

5ANY --- Absorb 1 (to absorb the 5 and keep the rest of the digits for the outgoing call)

911 --- Absorb None