tracing TNs in LD 80

[coniglio]

CEO has two phones in office and i need to add a key to both of them. He's on one of them. Both TNs are printed below (I took out some extraneous info). Do these printouts tell me that it's TN 26-7 that's actually being used? On the second TN 33-11 the first key it shows is key 3, then keys 0,1,2 and 4. Or do i have it backwards?

TN 026 0 00 07
KEY 0 SCR MARP IDLE
KEY 1 SCR MARP IDLE
KEY 2 SCR MARP IDLE
KEY 3 HOT ACTIVATED
ORIG 003 20 DID RMBR 3 20
TERM 033 0 00 11 3 HOT 0 2261 3904
_____________________________

.trak 33 11

TN 033 0 00 11
KEY 3 HOT ACTIVE TN 033 0 00 11

KEY 0 SCR IDLE
KEY 1 SCR IDLE
KEY 2 SCR IDLE
KEY 4 HOT IDLE

 

[Nortellian]

I beleive he is on 33 11. If you have a switch on your site you can mimic similar programming and test it at your site and see what happens.

 

[PERRYPJ]

NORTELLIAN IS CORRECT, IF YOU HAVE 2 TN'S WITH THE SAME APPEARANCES THE ONE THAT HAS THE KEY AT THE TOP OF THE TRAC IS ACTIVE

OLD ROLMEN WORKING ON NORTELS

 

[unkalary]

The call that was active (TN active) is 26 7. You can make changes to the other 33 11 without knocking him off the call.

 

[coniglio]

unkalary, you're telling me something that conflicts with what Nortellian and Perry PJ are saying. who's correct?

 

[StoneColdphoneman]

Nortellian and perry Pj are correct, unkalary is WRONG
Also Nortellian has good suggestion try to duplicate same scenario on your local switch
And see what happens that’s how you learn, do not look for easy way out, try solving problems your self.

Thank you, and have a good day.

 

[coniglio]

Thank you for the advice Stonecold but it actually wasn't a problem, it was a question that, even though I myself programmed both my phones on my desk and got the same scenario as shown above, I wanted to double-check with all you expert technicians at tektips so that i never, ever, ever cut off the chairman or the CEO because when their phones need to be changed they need to be changed IMMEDIATELY. Thank you again.