Trace to trunk

[Nibbio]

Md110 Bc09, connect via qsig with pabx A (Tenovis integral 55) and pabx B (Cisco Call Manager).

Cisco can call Tenovis but non vice-versa. Tenovis use 1040xxxx where xxxx is Cisco Extension).
I Activate q931 debug in cisco but I dont'receive any setup from Md110. Tenovis can call any Md110 extension, of course.

How can I activate trace in Md110 to know where is the problem?

Thank's a lot!!

 

[drewMk2]

CTCOPIR=XXXX; while the call is established will give you the EQU of the ext and the ip/equ of the trunk it is using.
let me know if you any further info and I will do my best nto get it to you