TR1034 Brooktrout

[telcomwork]

Does anyone have a configuraiton for a Brooktrout board TR1034, specifically trunk and DS1? We will have numbers coming in over our local T1 the I'll be redirecting toward the RightFax trunk I setup. Also if I'm connecting from a 120A CSU to the Brooktrout via an RJ45, they supplied a straight through cable, should I be using a cross with 1/2 and 4/5?

Many Thanks!

 

[telcomwork]

Here is what worked for me for today's install.

Two things to be cognizant on:
1. Used cross over from CSU to Brooktrout (1,2 and 4,5)
2. Had to run diag and upgrade firmware on card (had
inservice-active hung)

DS1 CIRCUIT PACK Location: 2b18 and 3c18
Name: FaxServer_Card2 and FaxServer_Card1
Bit Rate: 1.544
Line Coding: b8zs
Line Compensation: 1
Framing Mode: esf
Signaling Mode: robbed-bit
Interface Companding: mulaw
Idle Code: 11111111
Slip Detection? n
Near-end CSU Type: integrated DS1
Network Management Protocol: tabs
Send ANSI-T1.403 One-Second Performance Reports? n
Far-end CSU Address: b
Transmit LBO: 0db
Receive ALBO: 26db
Upon DTE LOS: loopback
Supply CPE Loopback Jack Power? n







TRUNK GROUP

Group Number: 4 Group Type: tie CDR Reports: y
Group Name: FaxServer COR: 1 TN: 1 TAC: 1404
Direction: two-way Outgoing Display? y Trunk Signaling Type:
Dial Access? n Busy Threshold: 255 Night Service:
Queue Length: 0 Incoming Destination:
Comm Type: rbavd Auth Code? n
Trunk Flash? n
BCC: 0
TRUNK PARAMETERS
Trunk Type (in/out): wink/wink Incoming Rotary Timeout(sec): 5
Outgoing Dial Type: tone Incoming Dial Type: tone
Wink Timer(msec): 300 Disconnect Timing(msec): 500
Digit Treatment: Digits:
Sig Bit Inversion: none
Analog Loss Group: 9 Digital Loss Group: 13
Incoming Dial Tone? y
Bit Rate: 1200 Synchronization: async Duplex: full
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0 Receive Answer Supervision? y


ACA Assignment? n Measured: both
Internal Alert? n Maintenance Tests? y
Data Restriction? n
Glare Handling: none
Used for DCS? n
Suppress # Outpulsing? n
Seize When Maintenance Busy: neither-end




Incoming Tone (DTMF) ANI: no Per Call CPN Blocking Code:
Connected to CO? n Per Call CPN Unblocking Code:

Ds1 Echo Cancellation? n

Incoming Disconnect(msec): 500 Outgoing Disconnect(msec): 500
Incoming Dial Guard(msec): 70 Outgoing Dial Guard(msec): 1600
Incoming Glare Guard(msec): 1500 Outgoing Glare Guard(msec): 1500



Outgoing Seizure Response(sec): 5
Programmed Dial Pause(msec): 1500 Disconnect Signal Error(sec): 240
Flash Length(msec): 540 Incoming Incomplete Dial Alarm(sec): 255





END TO END SIGNALING
Tone(msec): 350 Pause(msec): 150

OUTPULSING INFORMATION