I have an ethernet nic and a token ring nic in my netware 5.1 server. The token ring side is configured to hit the internet. I want the ethernet side to as well, but i have to use static ip on my ethernet side. how do i configure the ethernet side to reach the internet?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Token Ring and Ethernet
- Thread starter bucket28
- Start date
SuperDaveDCF
MIS
try giving your ethernet nic a private ip like 192.168.1.x and use the same subnet and gateway that the token ring nic is using. not sure that this will even work but it's worth a shot.
salserocito
MIS
Do each of these NICs have a different TCPIP addressing scheme? If so, and you are using INETCFG, you can setup a STATIC ROUTE that will forward data to the IP Address of the other NIC.
Good Luck!
Good Luck!
- Status
Similar threads
- Locked
- Question