Does anyone know how to install and configure a TN793B (24 - Port Analog Card) in a Definity G3R? I've never done this particular task, therefore I wasn't sure if the switch would recognize the card automatically once it was installed or not. Any help would be appreciated. Thanks!!!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
TN793B Installation
- Thread starter jbellizia
- Start date
The Definity will recognize the card automatically. Once you plug it in a vacant slot.
To check just do the "List Configuarations all" command and you should see it in the slot you installed it in.
If you did not, you can try installing it manually using the "change Circuit Pack" command...
Bajashark
To check just do the "List Configuarations all" command and you should see it in the slot you installed it in.
If you did not, you can try installing it manually using the "change Circuit Pack" command...
Bajashark
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question