if a g650 is used and there is no tn771dp would you see the med pro only show up with only channels 1, 3, 5 and 7??? IA770 is up and you can call it but you get dead air. using the processor ethernet and no CLAN. have the medpro connected to the 8400 enterprise LAN via xover.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
tn771DP needed?
- Thread starter ABCIP
- Start date
jimbojimbo
Vendor
I'm assuming you are on CM4.x.
Had a discussion with Avaya about this before. Tyou will only see channels 1,3,5, and 7. This ia apparently a more accurate view of the board but they didn't clear up the numbering so instead of 1-2-3-4 you get 1-3-5-7. This is normal.
Jimbo
Had a discussion with Avaya about this before. Tyou will only see channels 1,3,5, and 7. This ia apparently a more accurate view of the board but they didn't clear up the numbering so instead of 1-2-3-4 you get 1-3-5-7. This is normal.
Jimbo
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question