TN2313AP & G3r11

[grayml]

Hello all,

When I try to configure a TN2313AP with Signalling Mode set to ISDN-PRI I get the error "Requires TN2242, TN2464, DMM1, TN464C or later release circuit pack" What is going on? I thought that this was a new circuit pack than any of the ones referenced too in the error.

Thanks!

 

[AvayaTier3]

You can use it for isdn-ext which is all b-channels
This is similar to tn767E for g3r and IP connected systems.

Check the link below for Minimum Hardware Vintages and compatibility
[link ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/media/minhardwarevintages.pdf]Avaya Hardware vintages[/url]

tn2313AP
This code does not provide Echo Cancellation.
Consequently, this code should not be used in an IP
connected system. Use TN464GP or later. S87x0, S8500,
and S8400 systems do not support "D" channels on this
board.

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]