For single card installations, log in by entering:
L<CR>
The MMI then prompts for a password. The password is “LTILINK”, and it
must be typed all in capital letters.
After logging in, the prompt will then look like this:
• LTI:::> for single-card installations
Basic commands
MMI commands can now be executed. There are seven basic commands that
can be combined together to form a total of 19 command sets. They are:
• Alarm
• Clear
• Display
• Set
• Test
• Help
• Quit
If ?<CR> is typed, the MMI will list the above commands along with an
explanation of their usage A screen similar to the following will appear. The
help screen can also appear by typing H<CR>, or HELP<CR>.
Each of these commands can be executed by typing the first letter of the
command or by typing the entire command. Command sets are entered by
typing the first letter of the first command, a space, and the first letter of the
second command or by typing the entire command. Table 88 shows all the
possible command sets, listed in alphabetical order. These commands are
described by subject later in this section.
ALARM USAGE: Alarm [Enable | Disable]
CLEAR USAGE: Clear [Alarm] | [Error counter] [Log]
DISPLAY USAGE: Display [Alarm | Status | Perform |
History] [Pause]
HELP USAGE: Help | ?
SET USAGE: Set [Time | Date | Alarm | Clearing |
Name | Memory]
TEST USAGE: Test [Carrier All]
QUIT USAGE: Quit
Notation Used:
CAPS - Required Letters [ ] -
Optional
| - Either/
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.