TLU83 for 7.5.0.1.1

[utwo]

thread806-1672790

Hi, all,
How is it possible to configure TLU83 board for Mitel MX-ONE 7.5.0.1.1?


MDSH>> ROCAI:ROU=9,SEL=0110000000000010,SIG=400000000000,TRAF=01151515,TRM=4,SERV=2100000001,DIST=30,DISL=128,NODG=0,BCAP=001100;
EXECUTED

MDSH> RODAI:ROU=9,TYPE=TL11,VARI=00030508,VARO=00002815,VARC=00030022,FILTER=NO;
MDSH>> RODAI:ROU=9,TYPE=TL11,VARI=00030508,VARO=00002815,VARC=00030022,FILTER=NO;
NOT ACCEPTED
TYPE
NOT IN RANGE
MDSH>

 

[bpetya]

I think that the TL11 unit was not loaded into the system. Try to load it:
MDSH> pu_add -unit TL11
Then issue the commands

 

[utwo]

MDSH> pu_add -unit TL11
TL11 doesn't exist in system
MDSH> pu_add -unit TL95
TL95 doesn't exist in system
MDSH> pu_add -unit TL99
TL99 doesn't exist in system
MDSH> board_list
Device board position information

Boardpos Brdid Brdname Individs Signal State Status
format
1A-0-40 128 ELU34/6 32 long active assigned
1A-0-50 124 TLU83 12 long passive not assigned
1A-2-00 125 PRI 32 long passive not assigned
1A-2-10 125 PRI 32 long passive not assigned
1A-2-20 125 PRI 32 long passive not assigned
1A-2-30 125 PRI 32 long passive not assigned

END

 

[himdp]

Hi, for type TL11, you need program unit TLP11. Try pu_add -unit TLP11