TLU79 ISDN2e and BT

[slash50]

Hello,

I'm trying to set up a small site with TLU79's used as the only means of inbound/outbound with DDI.

I currently have the parameters:

<rodap:rou=all;
ROUTE DATA
ROU   TYPE  VARC        VARI        VARO        FILTER  
40    SL60  H'00000304  H'00000000  H'44410000  NO

END
 
<rocap:ROU=ALL;
ROUTE CATEGORY DATA
ROU SEL              TRM SERV       NODG DIST DISL TRAF     SIG          BCAP
40  0120100000000010 5   2110000000  0   30   128  00151515 011110100030 101100

END

But I cannot get synchronisation for them to work. I get "269 DIGITAL TRUNK, LOSS OF FRAME SYNCHRONIZATION " and the light on the ISDN2 boxes keeps flashing...

Any ideas? Many thanks!!

 

[whosrdaddy]

this means layer 1 is not active. is your cabling ok?

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[slash50]

I think so, I'm using the white/blue and white/green pair for circuit 1 and the white/orange and white/brown pair for circuit 2.

I have this wired into a RJ45 patch panel, I'm sure it was right, but if you have a definite answer then I'll double check.

Thanks Daddy ;o)

 

[whosrdaddy]

Loss of frame basically means that the card is not seeing any frame at all, you get the same error when disconnecting the cable of a working system.

In my country the signal pairs are blue/white-blue green/white-green at the NT1 side. Should be the same as in the UK.

Cheers,
Daddy

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[slash50]

Indeed you are the daddy, for some reason I'd got my colours mixed up.. whoops...

THANK YOU

 

[642234]

Hi Guys,

Help me cable connection with RJ 45 of TLU 79 board for each trunks circuits
Thanks