TLU76 Cable

[Monrovia]

hi all,

can somebody give me the cable connection diagram of TLU76 to a cisco router?

My router is fit outside the building near to a satellite dish. so, the cable which come with the TLU76 card has not enough length to reach the router. So i would like to make the cable manually.

and i dont want to use a switch/hub in between.

could you help me with the information that, which i am looking for.

Which pairs are to be punched to the RJ45 clip?
which points to the connector(to TLU76) are to be used

Thanks

 

[TeleLion]

gnd = A18
Tx = B19
gnd = A22
Rx = B23

On the RJ45 usulayy using pins 12,45.

TELEC3

 

[Monrovia]

12 & 45? i dont understand this.

there is only 1-8 pins in a RJ45 clip. then how come it is 12th pin & 45th pin?

do u mean: pins 1&2 && 4&5? I hope this is it.

A18 & B19 to 1&2
A22 & B23 to 4&5
Correct?


thanks tele. thanks a lot

 

[TeleLion]

yes, well 1,2 & 4,5 depend on the remote site as well, i don't know how Cisco does it, but try that, if it's not working, try switching the pairs 4,5 & 1,2, basically your TR goes on to the cisco's Rx, and your Rx goes into the cisco's Tx.

TELEC3