TLU27/6F

[nix8]

How setup termination of incoming call from subj.??

How setup concrete one ( of 6 ) trunk line ???
( If I have on first line PSTN and on second line GSM gate. How route call per right trunk line ?? )

 

[Avstral]

This is analog 2-wire loop-spart board.

To setup answering position use RODNI command:

RODNI:ROU= ,TRU= ,DAY= ,NIG= ;

where DAY/NIG - night or day service numbers.
You can use only DAY or only NIG or both.

But if you have different sytems connected to TLU27, it is not wise to program them in one route (if you plan use those lines for outgoing fraffic also).

Regards

 

[nix8]

1/
RODNI is not right way. I have selected TLU27 termination,
but I can not find it with command RODNP.



2/
I mean that on TLU76 exists predialled number for select
concrete timeslot and it must be similer for TLU27
I can write to LCDDI and "prediall" this, can't I?

 

[jinjin]

TRY,
RODNP:ROU=XX;
OR
RODNP:ROU=XX,TRU=ALL;
IF YOU WANT ALL THE CALLS ON THAT ROUTE TO TERMINATE TO CERTAIN DIR YYY,
RODNI:ROU=XX,NIG=YYY,DAY=YYY;

IF YOU WANT A PARTICULAR TRUNK ON THAT ROUTE,
RODNI:ROU=XX,TRU=A-B,NIG=YYY;

 

[nix8]

I have two TLU ( TLU76, TLU27/6F with 1. line GSM gate,
other line PSTN )
I want this
DEST ROU
61 ( TLU76 )
( 1. alternative TLU27/6F PSTN line )
( 2. alternative TLU27/6F GSM gate )
62 ( TLU27/6F PSTN)
( 1. alternative TLU76 )
( 2. alternative TLU27/6F GSM gate )
63 ( TLU27/6F GSM gate )
( 1. alternative TLU76 )
( 2. alternative TLU27/6F PSTN line )

If I dial no. 61xxxxxx I want go to TLU76
If I dial no. 62xxxxxx I want go to some PSTN line on TLU27/6F
but I want dial 63xxxx and go to
1. line on TLU27/6F or to alternative TLU76
after unsuccess dial on 1. alternative go to 2. alternative
other lines on TLU27/6F
How specify dest 61, 62, 63 ????

 

[nix8]

to 1/
RODNI is not right way. I have selected TLU27 termination,
but RODNI does not defined on my MD110.
Have you other way ???